enWanflow Cloud GatewayLAN and address assignment

LAN and address assignment

Before you start, sign in to the device as described in Sign in to the gateway admin console.

1. Open the LAN settings

In the left navigation, select 设置 → 网络 (Settings → Network). The Networks list shows the LAN lan and its subnet. Click lan to open the settings panel on the right.

2. Set the LAN address

Under IP Configuration, enter the device’s LAN address in CIDR format. The factory default is 192.168.77.1/24: 192.168.77.1 is the device’s own address, and /24 means the subnet is 192.168.77.0–192.168.77.255. To add more addresses, click Add IP Address.

If you plan to reach this LAN remotely through FlowMesh subnet routes, avoid using the same subnet as the remote side.

3. Set up address assignment (DHCP)

When you select Enable DHCP Server, the device automatically assigns addresses to connected devices:

SettingDescription
Start AddressThe starting number of the address pool. For example, 100 starts assigning from 192.168.77.100
Address LimitThe maximum number of addresses to assign
Lease TimeAddress lease time; for example, 12h means 12 hours
Custom DNSBy default, the device itself is used as the DNS server for devices. Select this to specify other DNS servers

4. Save the settings

Click Apply Changes to apply the settings. After changing the LAN address, devices need to obtain a new address, and you must use the new address to access the device locally.